Corner Freestanding Baths: Back and Side to Wall Baths Explained

White corner freestanding bath with two straight sides against the walls and a curved open side, brushed brass wall-mounted bath filler

TL;DR: Yes, you can have a freestanding bath in a corner. The neatest way is a corner freestanding bath, also called a back and side to wall bath: two straight sides sit flush against the walls and are sealed, while the open sides have the shaped, panel-free look of a freestanding bath. Ours start at £1,422 for the Juno 1500 x 750mm.

  • A normal roll top or freestanding bath can go in a corner too, but it needs a gap of at least 100 to 150mm from both walls to clean behind.
  • Our corner freestanding baths: Juno 1500 x 750mm (from £1,422), Juno 1700 x 800mm (from £1,504), Moda 1600 x 800mm (from £1,742) and the fluted Sofie 1700 x 800mm corner version (from £2,029).
  • They come in left or right hand versions, so check which wall the bath will sit against before you order.
  • Wall-mounted taps suit all of them and are easy to plumb, because the corner gives you two walls to run pipes in.
  • For a panelled, space-saving corner bath instead, see our corner baths from £1,111.

A freestanding bath can go in the corner of a room, and in most UK bathrooms a corner is the only place it fits. The question is which type of bath you choose. A fully freestanding bath is shaped on every side, so it never sits neatly against a wall. A corner freestanding bath is made for the job: it has two straight sides that go tight to the walls and can be sealed, and curved or finished sides facing the room, so it still looks like a freestanding bath.

Most retailers just list these baths under "corner and back to wall baths" without explaining how they work, which hand you need or how they compare with a roll top in the corner. This guide covers all of that, using the baths we sell and fit from our Birmingham showroom.

What is a corner freestanding bath?

A corner freestanding bath (also sold as a back and side to wall bath, a back to wall corner bath or a corner to wall bath) is a freestanding-style bath with two flat sides. One long side goes against the back wall and one end goes against the side wall. The other two sides are finished, so there is no bath panel. Because the flat sides meet the walls, you can seal them with silicone just like a standard bath, and there is no awkward gap behind the bath to clean.

It sits between a freestanding bath, which needs space all round, and a standard panelled bath, which needs an alcove. It is also different from a traditional corner bath, which is a square or offset bath with a curved front panel that fills the corner.

Our corner freestanding baths

Bath Size Look Handing Taps From
Juno 1500 1500 x 750mm Two straight sides, one curved end sweeping into the room Left or right hand No tap holes: wall-mounted or floor-standing £1,422
Juno 1700 1700 x 800mm As above, full-length Left or right hand No tap holes: wall-mounted or floor-standing £1,504
Moda 1600 x 800mm, 250 litres Modern back to wall corner design, white or almost any colour to order Left or right hand See product page £1,742
Sofie corner 1700 x 800 x 580mm, 180 litres Fluted on the two open sides Left or right hand corner (also a back to wall version) Corner-mounted or wall-mounted £2,029

All four are acrylic and come with a waste and overflow. The Juno and Sofie offer matt black or brushed brass waste upgrades, and the Moda comes with chrome as standard, with white, matt black and brushed brass kits as options. The Sofie and Moda can also be painted or finished in almost any colour to order. Every product page has a downloadable spec sheet or full dimensions so you can check it against your room.

Corner freestanding bath vs corner bath vs a roll top in the corner

Corner freestanding bath Panelled corner bath Freestanding or roll top in a corner
Look Freestanding from the room side Square or offset with a curved panel Shaped on every side
Against the walls Two sides sealed flush Two sides sealed flush Needs 100 to 150mm gaps to clean
Floor space Same as a standard bath of that size Square ones take more floor (1200 x 1200mm and up) Bath plus gaps on two sides
Shower over Possible with a wall valve and curtain Possible, with a curtain Possible, but splashes the gaps
Our examples Juno, Moda, Sofie corner Carron Oriole 1200 x 1200mm (from £1,180), Carron Dove 1550 x 950mm offset (from £1,111) Roll top baths

If you want the freestanding look and a bath that is easy to keep clean, a corner freestanding bath is usually the best fit. If you want the most bathing space for the floor area, or a bath for two, a panelled corner bath such as the 1500 x 1500mm Carron Centennial (from £1,623) or the 1700 x 1000mm offset Carron Omega (from £1,439) gives more room. Our corner baths guide compares those in detail.

Left hand or right hand?

Corner freestanding baths are "handed" because only two sides are straight. The handing tells you which corner it fits. As a rule of thumb for the Juno, stand in the room facing the open, curved side of the bath: if the side wall is on your right, you need a right hand bath, and if it is on your left, a left hand bath.

Manufacturers do not all use the same convention, so always check the plan drawing on the spec sheet against a sketch of your room before you order, and ask us if you are unsure. A handed bath cannot be swapped round once it is fitted. Our guide to left or right hand baths and vanity units explains handing in more detail.

How to measure for a corner freestanding bath

  1. Measure both walls from the corner, at the height of the bath rim and at floor level. You need at least the bath length along one wall and the bath width along the other.
  2. Check the corner is square. Very few room corners are exactly 90 degrees. A small gap at one end can be closed with silicone, a tile trim or by tiling down to the rim, but a big gap is hard to hide. Measure 600mm out along each wall and the diagonal between those points should be about 850mm.
  3. Allow for wall finishes. New tiles or wall panels on plasterboard take 10 to 20mm off each wall.
  4. Check the waste position on the spec sheet and make sure your waste pipe can reach it, especially on a solid floor.
  5. Leave room to get in and out. Around 700mm clear beside the open side of the bath is comfortable.

Can you put a roll top bath in a corner?

Yes, as long as you leave a gap of at least 100 to 150mm from both walls so you can clean behind it and reach the waste. Because a roll top is curved on every side, you cannot seal it to the walls, so water and dust will collect in the gaps if you push it tight into the corner. In a larger room, angling a roll top or slipper bath across the corner can look striking, but it takes a lot more floor space.

If you want the roll top look and a sealed, easy-clean fit, a corner freestanding bath is the better choice. Our back to wall baths guide covers how far a freestanding bath needs to be from a wall.

Can you shower over a corner freestanding bath?

Yes. The two walls make it easier than over a fully freestanding bath. Fit a wall-mounted shower valve with a riser rail or fixed head on one of the walls at the plug end, and hang a curtain from a ceiling-mounted track around the open sides. A fixed glass screen is harder, because most of these baths have a curved open side for the glass to sit on, so we check this on site. If you plan to shower every day, a straight bath or a shower bath with a glass screen is more practical. See our guide to a roll top bath with shower for more ideas.

Taps for a corner freestanding bath

The Juno has no tap holes, so you choose between two options:

The Sofie corner bath is designed for corner-mounted taps, and wall-mounted taps work with every bath on this page. Plan the taps before the bath goes in so the pipework lines up.

Corner freestanding baths for small bathrooms

The Juno 1500 x 750mm is our most compact corner freestanding bath. It takes the same floor area as a standard 1500mm bath, but gives you the freestanding look, and because two sides are sealed to the walls there is no wasted gap behind it. That makes it a good choice for a small family bathroom where a full freestanding bath would not fit. See our small baths, our small bath sizes guide and our small bathroom layouts for worked plans.

Want the fluted look?

The Sofie corner version is fluted on both open sides, which suits Art Deco and modern rooms alike. See all our fluted baths or the full fluted bathroom collection.

Prices include VAT and were correct at the time of writing. Check the product page for the current price.

Shop this guide

Add to your basket here, or choose a finish or size without leaving the page.

Frequently asked questions

Can a freestanding bath go in a corner?

Yes. A corner freestanding (back and side to wall) bath is made for it, with two straight sides that seal to the walls. A normal freestanding bath can also go in a corner if you leave a 100 to 150mm gap from both walls.

What is a back and side to wall bath?

A freestanding-style bath with one long side and one end that sit flat against two walls, so it fits a corner and can be sealed. The open sides have no panel.

How do I know if I need a left or right hand corner bath?

For the Juno, stand facing the open side of the bath: if the side wall is on your right, choose right hand. Conventions vary, so check the spec sheet drawing or ask us.

What is the smallest corner freestanding bath?

Our smallest is the Juno at 1500 x 750mm, from £1,422. For a smaller footprint, a panelled 1200 x 1200mm corner bath is the next option.

Can you put a roll top bath in the corner of a bathroom?

Yes, but leave a gap from both walls to clean behind it, as a roll top cannot be sealed to the wall. For a sealed fit, choose a corner freestanding bath.

Do corner freestanding baths have tap holes?

The Juno has none, so it needs wall-mounted taps or a floor-standing filler. The Sofie corner bath takes corner-mounted taps. Wall-mounted taps suit all of them.

Plan your corner bath

Not sure which corner bath fits, or which hand you need? Send us a sketch with your measurements and we will check it for you. Visit our showroom at 32 Manor Park Rd, Birmingham B36 0DJ (Tuesday to Saturday, 9am to 5pm), call 0121 794 2553 or book your free consultation online. Every project starts with a free one-to-one consultation and a clear, itemised quote.